Vallejo Hobby Maling Primer Spray er den perfekte kombination af en base coat og en højt pigmenteret farve, udviklet til brug på alle typer metaller, plastik og resin modeller og miniature figurer.
Den originale og unikke spray formel tørrer hurtigt og giver et flot, mat, selvnivellerende finish, der frembringer selv de fineste detaljer på dine modelprojekter.
På spraydåsen ses i toppen en farvet ring, denne angiver malingens farve.
Der medfølger to forskellige dyser: en med lavt udløbsflow, der er velegnet til maling af små og præcise detaljer. Samt en med medium udløbsflow, velegnet til mellem og større flader.
Indeholder: 400 ml
Farve: Bronze Green
© Legeland.dk
LABEL ELEMENTS:
This product is labelled with the signal word DANGER in accordance with Regulation (EU)
No. 1272/2008~2017/776 (CLP)
Hazard statements:
H222 Extremely flammable aerosol.
H229 Pressurised container: may burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
EUH066 Repeated exposure may cause skin dryness or cracking.
Precautionary statements:
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P103 Read label before use.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P271-P260d Use only outdoors or in a well-ventilated area. Do not breathe aerosol.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50ºC/122ºF.
P501a Dispose of contents/container in accordance with local regulations.
Supplementary statements:
None.
Substances that contribute to classification:
n-butyl acetate
Ethyl acetate
DESCRIPTION OF FIRST-AID MEASURES:
Symptoms may occur after exposure, so that in case of direct exposure to the product, when in doubt, or when symptoms persist, seek
medical attention. Never give anything by mouth to an unconscious person. Lifeguards should pay attention to self-protection and use the
recommended protective equipment if there is a possibility of exposure. Wear protective gloves when administering first aid.
Route of exposure Symptoms and effects, acute and delayed Description of first-aid measures
Inhalation: Inhalation of solvent vapours may produce headache,
dizziness, fatigue, muscular weakness, drowsiness
and, in extreme cases, unconsciousness.
Remove the patient out of the contaminated area into the fresh
air. If breathing is irregular or stops, administer artificial
respiration. If the person is unconscious, place in appropriate
recovery position. Keep the patient warm and at rest until
medical attention arrives.
Skin: Prolonged contact may cause skin dryness. Remove immediately contaminated clothing. Wash thoroughly
the affected area with plenty of cold or lukewarm water and
neutral soap, or use a suitable skin cleanser. Do not use
solvents or thinners.
Eyes: Contact with the eyes produces redness and pain. Remove contact lenses. Rinse eyes copiously by irrigation with
plenty of clean, fresh water for at least 15 minutes, holding the
eyelids apart, until the irritation is reduced. Call a physician
immediately.
Ingestion: If swallowed, may cause irritation of the throat,
abdominal pain, drowsiness, nausea, vomiting and
diarrhoea.
If swallowed, seek medical advice immediately and show
container or label. Do not induce vomiting. Keep the patient at
rest.
© Legeland.dk
